D-Plate & Aluminum Wheel Set

$174.99

Aluminum wheel set and D-Plate for 2×72

Category:

Description

Aluminum Wheel set and D-Plate with spacer

The set consists of:

One, Steel D-Plate is CNC cut from 3/8″ steel. 1/8″ spacer is also included.Wheel mounting holes are 1/2″-13 tapped. The centre mounting hole is 1/2″ diameter, the slots for a flat platen mounting bracket are 1/4″ wide and 6″ apart, the u-shaped adjusting slot accepts a 3/8″ bolt. The axle holes are 10.5″ center to centre and will accept an 8″ long flat platen if you use 2″ diameter wheels.

Two, 2″ diameter x 2-1/4″ wide precision CNC lathe turned aluminum Idler Wheels with sealed 6202 bearings and CNC machined spacer between the bearings to prevent over tightening.

One, 3″ diameter x 2-1/4″ wide precision CNC lathe turned aluminum Tracking Wheel with sealed 6202 bearings CNC machined spacer between the bearings to prevent over tightening. The tracking wheel is crowned on a CNC lathe to ensure accurate belt tracking.

One, 4″ diameter precision CNC lathe turned aluminum Drive Wheel. The drive wheel is crowned to ensure accurate belt tracking. The face of the drive wheel is 2-1/4″.  The set screw (included) is 1/4-20 & 1/2″ long and is offset to assist with the installations on shorter drive shafts. Please note that the bore of this drive wheel is 5/8″ and also has a standard key way.

Axle bolts, washers and nuts are not included.

Additional information

Weight 5.00 kg
Dimensions 36.5 × 20.5 × 16.5 cm

You may also like…